Cartek Afterburner Rain Light Pigtail Set

All of our Cartek Afterburner Rain Light Adapters are designed using 3-pin Deutsch DTM connectors. If you’re looking to use our adapters on your own rain light wiring but do not have the ability to properly crimp the Deutsch pins, these fully assembled pig tails can be spliced into your wiring therefore allowing the adapters to simply plug in.

Chassis Connector – 3-pin Deutsch DTM Plug:

• 1 – 0.50mm² Red – +12V from On/Off Switch
• 2 – 0.50mm² Blue – +12V from Brake Switch
• 3 – 0.50mm² Brown – Chassis Ground

Rain Light Connector – 3-pin Deutsch DTM Receptacle:

• 1 – 0.50mm² Yellow – Cartek Afterburner Yellow Wire
• 2 – 0.50mm² Red – Cartek Afterburner Red Wire
• 3 – 0.50mm² Black – Cartek Afterburner Black Wire

Notes:

– Wire Length: 305mm / 12″

– Preferred splicing method: non insulated butt splice sealed with adhesive lined heat shrink.