BMW 2-pin Black Sealed Receptacle, E36 High Beam Connector Kit

It is common to run aftermarket lights on a race car due to being cheaper, lighter, and/or higher output. Typically your only option is to cut off the stock connector and splice in the new light. Depending on the new light you use it may not have a connector which would result in the light being directly connected to your wire harness unless you add some other connector between the wire harness and light.

Rather than dealing with that and cutting the stock connector you can simply use the mating connector for the stock connector, therefore allowing your new lights to just plug in and also allowing you to revert back to the stock lights.

BMW 2-pin Black Sealed Receptacle, E36 High Beam Connector Kit Contents:

• 2x – Black Receptacles
• 2x – Blue Lock
• 5x – Pins for 1.50 – 3.00mm² (1 spare)
• 5x – Seals for 2.03 – 2.85mm  insulation diameter (1 spare)

BMW 2-pin Black Sealed Receptacle, E36 High Beam Pigtail Kit Contents:

• A pair of connectors fully assembled with 1.50mm² FLRYW, approximately 300mm (12″) long.

Application List: (partial, compare your connector to others listed here)

• BMW E36 High Beam
• BMW E39 High Beam
• BMW E46 High Beam
• BMW X3 E53 High Beams

Notes:

– Although this connector appears different than what is on many BMW models such as the E46, it will properly connect and seal to the stock connectors.

– All items within this connector kit are genuine items sourced from authorized distributors.